Power Supply Module Installation
Power Supply Module Installation
This section describes how to remove and install a new or replacement power supply module in Catalyst
•Tools and Equipment, page 5
•Installation Guidelines, page 5
•Installing an AC-Power Supply, page 6
•Installing a
Tools and Equipment
Obtain these necessary tools and equipment:
•Ratcheting torque screwdriver with a
•
Installation Guidelines
Observe these guidelines when removing or installing a power supply module:
•Do not force the power supply module into the slot. This can damage the pins on the switch or the RPS 2300 if they are not aligned with the unit.
•A power supply module that is only partially connected to the switch or the RPS 2300 can disrupt the system operation.
•Remove power from the power supply module before removing or installing the module.
•The switch supports hot swapping of the power supply when the switch is connected to an RPS 2300 that can provide backup power. You can remove and replace the power supply without interrupting normal switch operation. When you insert a new power supply in the switch, there is a
•The RPS 2300 supports hot swapping of the power supply module when an external device is connected to it.
–If the RPS 2300 is not backing up an external device, you can remove and replace the power supply module without disconnecting the system power.
–If two
–The RPS 2300 does not support hot swapping of the power supply module when two
•Make sure that you tighten the power supply module captive screws before moving the switch or the RPS 2300.
•When replacing the
Installation Notes for Catalyst
| 5 |
| |
|
|