Power Supply Module Installation
Installing a DC-Power Supply (Only Catalyst 3750-E and 3560-E Switches)
To connect the switch to a
1.Preparing for Installation, page 8
2.Grounding the Switch, page 9
3.Installing the DC Power Supply in the Switch, page 10
4.Wiring the DC-Input Power Source, page 11
Warning An exposed wire lead from a
Warning Before connecting or disconnecting ground or power wires to the chassis, ensure that power is removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the circuit breaker in the OFF position. Use a voltmeter to test for 0 (zero) voltage at the power terminals on the chassis. Statement 196
Warning This product relies on the building’s installation for
Note The grounding architecture of this product is
Preparing for Installation
Obtain these necessary tools and equipment:
•Ratcheting torque screwdriver with a
•Panduit crimping tool with optional
•
•
•
•Ground lug screw and lug ring in the switch accessory kit. For a dual ground connection, also use the
•Four leads of
•Four round eyelet terminals or four
Installation Notes for Catalyst
8 |
| |
|