Cisco Systems RPS 2300, 3560-E, 3750-E technical specifications Installing an AC-Power Supply

Power Supply Module Installation

Warning Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed circuitry could constitute an energy hazard. Statement 206

Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030

Warning Do not work on the system or connect or disconnect cables during periods of lightning activity. Statement 1001

Installing an AC-Power Supply

	To remove and install an AC-powered power supply module, follow these steps:
Step 1	Turn off the power at its source.
Step 2	Detach the power cord retainer from the power cord.
Step 3	Remove the power cord from the power connector.
Step 4	Use a Phillips screwdriver to loosen the two captive screws at the lower edge that secure the power
	supply to the chassis.
Caution	Do not leave the power supply slot open for more than 90 seconds while the switch or the RPS 2300 is
	operational.
Step 5	Remove the power supply module from the power slot by pulling on the extraction handle.
Step 6	Insert the new power supply into the power supply slot, and gently push it into the slot (Figure 4 and
	Figure 5). When correctly inserted, the power supply is flush with the panel. Note: the 1150-W power
	supply module extends 3.6 inches (9.14 cm) from the panel.
	Figure 4	Inserting an AC-Power Supply into a Switch

100-240 V 10-5 A

50-60 HZ

AC OK PS OK

158122

Installation Notes for Catalyst 3750-E, Catalyst 3560-E Switches and RPS 2300 Power Supply Modules

6 78-17570-01