vi

Ensure the ground connection on the power supply is correct and functioning before applying power to the Topspin system.

CAUTION: Always ground yourself before touching any internal Topspin system components to avoid damage from electrostatic discharge (ESD).

CAUTION: The Topspin system has two power cables. The operator must disconnect all power cables before attempting to remove the system from the rack.

CAUTION: Remove power cables by grasping the cable connector and pulling straight out.If the chassis comes equipped with a power-plug retainer, move the bail wire used to retain the plug to the side before attempting to remove the power plug. Replace power-supply cables be grasping the cable connector, align the connector with the power jack, and insert the connector straight into the jack.If the chassis comes equipped with a power-plug retainer, move the bail wire back into place to keep the power plug firmly in place.

CAUTION: The Topspin system contains lithium batteries. Do not attempt to replace or discard these batteries. The batteries may only be serviced by Topspin service personnel.

CAUTION: Observe and follow service markings. Do not service the Topspin system, except as explained in the Topspin documentation supplied with your system. Opening the chassis or removing the enclosure cover exposes you to electrical shock and may damage system components.

If one or more of the following situations occurs, remove power to the Topspin system chassis, and contact your Topspin support representative:

The power cable or power plug is damaged.

The system has been exposed to water.

The system has been dropped or damaged in any way.

The system does not operate correctly after following the installation instructions.

CAUTION: You must ensure the operating environment has adequate air circulation. Keep the Topspin in a cool, well-ventilated room. Do not block cooling vents. Install filler panels into all unused slots.

CAUTION: Use only Topspin-approved gateway expansion modules, controller cards, fans, and power supply modules.

Page 6
Image 6
Cisco Systems SFS 3001 quick start