11
Cisco SFS 3504 Multifabric Server Switch Installation and Configuration Note
78-18335-01
Verifying the Installation
Verifying the Installation
To verify your installation and configure basic connectivity, you must power-on the
Cisco SFS 3504 ServerSwitch and configure it through the serial console port from a terminal or
workstation.
Warning
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
when servicing.
Statement 1034
To verify the installation of your Cisco SFS 3504 Server Switch, perform the following steps:
Step1 Use the serial cable (provided) to connect the serial console port of the InfiniBand switch card in slot 5
of your Cisco SFS 3504 Server Switch to a terminal or to a workstation that runs terminal-emulation
software.
Step2 Launch a terminal session with the following parameters
•Baud: 9600 bps
•Data Bits: 8
•Parity: None
•Stop Bits: 1
•Flow Control: None
Step3 Connect a power cord to your Cisco SFS 3504 Server Switch, and then plug the cord into an appropriate
power source. The Cisco SFS 3504 Server Switch boots.
Step4 After the system boots, press the Enter key several times to display the CLI login prompt.
Login:
Step5 Enter super as your user ID and password to log in as a user with administrative privileges.
Login: super
Password: super
SFS-3504>