3
Cisco SFS 3504 Multifabric Server Switch Installation and Configuration Note
78-18335-01
Parts List
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement1017
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
Statement 1024
Warning
Only trained and qualified personnel should be allowed to install, replace, or service thisequipment.
Statement 1030
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both.
Statement 1043
Warning
This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations.
Statement 1045
Warning
Use of controls, adjustments, or performing procedures other than those specified may result in
hazardous radiation exposure.
Statement 1057
Parts List
The Cisco SFS 3504 Server Switch kit contains the following parts:
•One 5-slot multifabric server switch chassis
•One InfiniBand switch card
•One to four gateway modules, depending upon your configuration:
–
Ethernet gateway Product ID: SFS-3500-ENGW-1G
–
Fibre Channel gateway Product ID: SFS-3500-FCGW-4G
•Zero to three gateway blanking panels for I/O slots, depending upon your configuration
•One or two power supplies, depending upon your configuration
•Zero or one power supply blanking panel, depending upon your configuration