22
Cisco SFS 3504 Multifabric Server Switch Installation and Configuration Note
78-18335-01
Connecting the 10/100 Ethernet Management Port
Step8 Make selections as appropriate for your needs, and then click Next.
The Pre-Installation Summary screen appears.
Step9 Verify installation information in the Please Review the Following Before Continuing window, and then
click Install.
Step10 The installation executes.
Step11 Click Done when the installation completes.

Connecting to Element Manager

Factory defaults permit your server switch to connect to Element Manager. No configuration is
necessary.
To connect to Element Manager, perform the following steps:
Step1 Launch Element Manager. The Open Device - SFS Element Manager window appears.
Step2 In the Device Name or IP Address field, enter the IP address or the network name of the device that you
want to manage.
Step3 In the SNMP Community field, enter this community string: private.
Step4 Click Open to establish a connection.
Connecting the 10/100 Ethernet Management Port
The autosensing 10/100 Ethernet management port is located on the rear panel/port connectors side of
the Cisco SFS 3504 Server Switch. The Ethernet management port is used for out-of-band management
of the Cisco SFS 3504 Server Switch.
Use the CAT-5 twisted pair RJ-45 straight-through cable to connect the 10/100 Ethernet management
port to external hubs, switches, and routers.
Troubleshooting
For all customers, partners, resellers, and distributors who hold valid Cisco service contracts, Cisco
Technical Support provides 24-hour technical assistance. The Cisco Technical Support Website on
Cisco.com features extensive online support resources. In addition, Cisco Technical Assistance Center
(TAC) engineers provide telephone support. If you do not hold a valid Cisco service contract, contact
your reseller.