Chapter 5 Opening a PIX Firewall Chassis
Opening a PIX 510 and PIX 520
Step 5 Pull the top panel up as shown in Figure
Figure
ACT NETWORK
PIX FirewallSERIES
24286
Opening a PIX 510 and PIX 520
Follow these steps to open a PIX 510 and PIX 520 chassis:
Step 1 Read the Cisco PIX Firewall Regulatory Compliance and Safety Information document for your respective software version referenced in the section, “Related Documentation” in “About This Manual.”
Step 2 Ensure that the PIX Firewall is powered off. Unplug the power cord from the power outlet. Once the upgrade is complete, you may safely reconnect the power cord.
Warning Before working on a system that has an On/Off switch, turn OFF the power and unplug the power cord.
Installation Guide for the Cisco Secure PIX Firewall Version 5.2
|
| ||
|
|