Chapter 5 Opening a PIX Firewall Chassis
Opening a PIX 515
Opening a PIX 515
Follow these steps to open a PIX 515:
Step 1 Read the Cisco PIX Firewall Regulatory Compliance and Safety Information document for your respective software version referenced in the section, “Related Documentation” in “About This Manual.”
Step 2 Ensure that the PIX 515 is powered off. Unplug the power cord from the power outlet. Once the upgrade is complete, you may safely reconnect the power cord.
Warning Before working on a system that has an On/Off switch, turn OFF the power and unplug the power cord.
Step 3 As shown in Figure
Figure
Top panel screws (4)
DO NOT INSTALL INTERFACE |
|
|
|
CARDS WITH POWER APPLIED |
|
|
|
100 Mbps Link | FDX | 100 Mbps Link |
|
| FDX | ||
10/100 ETHERNET 0/0 | 10/100 ETHERNET 0/0 | ||
|
|
FAILOVER
CONSOLE
24305
Step 4 With the front of the unit facing you, push the top panel back by about one inch as shown in Figure
Figure
POWER | ACT NETWORK |
PIX FirewallSERIES
24285
Installation Guide for the Cisco Secure PIX Firewall Version 5.2
| ||
|