Cisco Systems WAP4410N

Setting Up the WAP4410N Wireless-N Access Point

Navigating the Utility

WAP4410N Wireless-N Access Point with Power Over Internet 16

•VLAN & QoS—Configures the 802.1Q VLAN and the Quality of Service

(QoS) settings.

•Advanced Wireless Settings—Configures the access point’s more

advanced wireless settings (for example, load balancing and channel

bandwidth).

AP Mode

This screen allows you to select the mode of operation for the access point. The

default mode is Access Point.

Administration

This screen allows you to manage the access point.

•Management—Configures the password and Simple Network

Management Protocol (SNMP) settings.

•Log—Configures the log settings.

•Diagnostic—Allows you to perform diagnostic activities, which can be

useful in solving network problems.

•Factory De fault—Resets the access point to its factory default settings.

•Firmware Upgrade—Upgrades the access point’s firmware on this screen.

•Reboot—Reboots the access point.

•Config Management—Saves and restores access point configuration.

Status

This screen allows you to view status information about your local network,

wireless networks, and network performance.

•Local Network—Displays system information, including software and

hardware versions , MAC address, and IP address on the LAN side of the

access point.

•Wireless—Displays wireless network settings including SSID, network

mode, priority setting, VLAN trunk, and wireless channel.