Cisco Systems WBP54G Product Usage Restrictions, Open the Wireless Network Connection window

Models: WBP54G

1 55
Download 55 pages 1.7 Kb
Page 48
Image 48
Product Usage Restrictions

Wireless-G Bridge for Phone Adapters

Product Usage Restrictions

This product is designed for indoor usage only. Outdoor usage is not recommended.

This product is designed for use with the standard, integral or dedicated (external) antenna(s) that is/are shipped together with the equipment. However, some applications may require the antenna(s), if removable, to be separated from the product and installed remotely from the device by using extension cables. For these applications, Linksys offers an R-SMA extension cable (AC9SMA) and an R-TNC extension cable (AC9TNC). Both of these cables are 9 meters long and have a cable loss (attenuation) of 5 dB. To compensate for the attenuation, Linksys also offers higher gain antennas, the HGA7S (with R-SMA connector) and HGA7T (with R-TNC connector). These antennas have a gain of 7 dBi and may only be used with either the R-SMA or R-TNC extension cable.

Combinations of extension cables and antennas resulting in a radiated power level exceeding 100 mW EIRP are illegal.

Power Output of Your Device

To comply with your country’s regulations, you may have to change the power output of your wireless device. Proceed to the appropriate section for your device.

NOTE: The power output setting may not be available on all wireless products. For more information, refer to the documentation on your product’s CD or http://www.linksys.com/international.

Wireless Adapters

Wireless adapters have the power output set to 100% by default. Maximum power output on each adapter does not exceed 20 dBm (100 mW); it is generally 18 dBm (64 mW) or below. If you need to alter your wireless adapter’s power output, follow the appropriate instructions for your computer’s Windows operating system:

Windows XP

3.Double-click the Wireless icon in your desktop’s system tray.

4.Open the Wireless Network Connection window.

5.Click the Properties button.

6.Select the General tab, and click the Configure button.

7.In the Properties window, click the Advanced tab.

8.Select Power Output.

9.From the pull-down menu on the right, select the wireless adapter’s power output percentage.

Appendix H: Regulatory Information

43

Page 48
Image 48
Cisco Systems WBP54G manual Product Usage Restrictions, Open the Wireless Network Connection window