2
Product Overview
Linksys WES610N/WET610N
2
Thank you for choosing the Linksys Dual-Band N Entertainment Bridge The
bridge can connect any wired, Ethernet device to your wireless network
The bridge is based on dual-band Wireless-N, so it is compatible with any
Wireless-N, -G, -A, or -B router or access point For first-time installation, follow
the steps on the CD folder To configure advanced settings, use the convenient,
browser-based utility
LED panel
WES610N WET610N
Wireless (Blue) The Wireless LED lights up when there is
a wireless connection The LED flashes when the bridge
is actively sending or receiving data over the wireless
network
Wi-Fi Protected Setup Button If your router supports
Wi-Fi Protected Setup and uses WPA or WPA2 security,
then you can use Wi-Fi Protected Setup to automatically
connect the bridge To use Wi-Fi Protected Setup, refer to
“Wireless > Basic Wireless Settings” on page 7
Wi-Fi Protected Setup LED (Blue/Amber) The LED flashes
blue for two minutes dur ing Wi-Fi Protected Setup It
lights up blue when wireless security is enabled If there
is an error during the Wi-Fi Protected Setup process, then
the LED lights up amber Make sure the network router
supports Wi-Fi Protected Setup Wait until the LED is off,
and then try again
Ethernet (Blue) The Ethernet LED lights up when there
is a wired connection The LED flashes when the bridge
is actively sending or receiving data over the Ethernet
port(s)
Power (Blue) The Power LED lights up when the bridge
is powered on
Product Overview