1Setup

Part Names and Functions

1

 

 

2

 

 

3

-1

6

 

 

4

-1

 

5

 

7

3

-2

8

 

 

4

-2

 

1Thermal printhead

This is the printhead. Avoid touching this with your fingertips and leaving grease or dirt on the printhead surface.

2Sensor arm

The media can be installed by raising this arm.

The media can be held in place by lowering this arm.

3Upper sensor (3-1) and bottom sensor (3-2)

When used as a transparent sensor (for labels and tags with notches), it is used by matching the sensor markings of the upper sensor and the bottom sensor. When used as a reflective sensor, it is used by matching the sensor marking on the bottom sensor with the position of the black mark on the liner or media backing.

4Media guides

(Left fixed media guide (4-1) and right movable media guide (4-2))

The end of the media is matched to the left fixed media guide, then the right side movable media guide is moved horizontally to match it to the media size. And the movable media guide is used as a guide to match the upper sensor and bottom sensor when using the transparent sensors.

5Platen

Interlocked with the thermal printhead, it feeds media backwards or forwards.

6Optional unit connector cover

It is opened when the cables of the cutter unit and the peeler unit are connected. Do not remove during normal use.

7Media holder guide

This guide is moved horizontally to match the media size. The guide can be sliding it from the holder bar.

8Media holder bar

The media is supported by the media holder bar when installed in the printer.

14