Printer Operation

Setting the Media

Installing the Media

1.Push the large blue-head open lever to release the head unit, and then lift the sensor arm by hand as shown below.

Head unit

Sensor arm

Large blue-head open lever

2.Firstly, slide the two black plastic parts of the media holder assembly together. Ensure correct alignment of the guide with

the bar as it can only be installed in one direction.

Media Sizes (p.22)3. Slide the roll of media over the media bar. The media guide must be on the right side of the roll of media (as viewed from the front of the printer) with the ribbed surface of the media guide touching the media roll as shown in the illustration.

Media holder guide

Media holder bar

4.Set the media roll and media holder in to the printer as shown above. It is advisable to pull a length of media forwards and through the mechanism ready for later positioning.

5.Move the media roll so it is touching the leftside of the housing. Then slide the black media guide so it is touching the media on

the right side.

Note: Do not try to hold the media too tightly with these guides as it will cause the printer to jam during printing.

23