Input Buffer BACK-UP Function | Citizen Systems CBM-730, CBM-720

CBM-710/720/730/750 User ’s Manual

7. INPUT BUFFER BACK-UP FUNCTION

7.1 Input Buffer Back-up

If the power is turned off, or there is a power failure during printing, the data in the input buffer will be retained. When the power comes back on, the power failure symbol (..... PD) will be printed in red, and then the data which

was interrupted will be printed from the beginning of the line where the interruption occurred.

Note: The input buffer back-up function may not operate properly if the related capacitor is not sufficiently charged. This may be the case if the printer has not been operated for a long period of time. After the printer power switch has been turned on for 10 minutes, the buffer back-up should be effective for approximately 100 hours or more.

7.2 Clearing the Input Buffer

In case it is desired to delete the data in the input buffer, the power switch should be turned on while pressing the LINE switch. When deletion of the buffer is completed the buzzer will sound. Please be sure to continue pressing the LINE switch until that time.

If the printer fails to work properly at the time the power switch turned on, please delete the input buffer as described above before inputting new data.

20

CITIZEN

Image 26

Citizen Systems CBM-730, CBM-720, CBM-750 Input Buffer BACK-UP Function, Input Buffer Back-up, Clearing the Input Buffer

Contents

Page Declaration of Conformity Important Safety Instructions Sicherheitshinweis Contents 11.1 Introduction FeaturesAccessories Type Classifications CBM-710 23 R Specifications General Specifications CBM-710 CBM-720 Paper Specifications Print Format Block Diagram External Appearance and Pars Descriptions CBM-710 External Appearance CBM-720 External Appearance Front View CBM-730 External Appearance CBM-750 External Appearance Part Descriptions Setting and Removing the Paper and Ribbon Covers Operation Opening and Closing the Cutter Unit CBM-720. CBM-750 Installing the Cassette Ribbon Installing and Changing the Paper Installing the Paper Citizen Citizen Paper End Detector Procedures for Actuating the Self Print FunctionSelf Print Function Changing the Paper Installation of the CBM-750 Clearing the Input Buffer Input Buffer BACK-UP FunctionInput Buffer Back-up Parallel Interface SpecificationsConnector Pin Assignment Description of Input/Output Signals Input/Output Signals Electrical Characteristics Timing Chart Serial Interface DTR Description of Input/Output Signals Error Detection Data Composition Data Receiving Control Buffering Output DTR, TD Ready Setting DIP Switch DS1 Function Selection DIP Switch DS2 Serial interface specifications only Slide Switch Setting Serial interface specifications only DIP Switch and Slide Switch Locations Print Control Functions Control Codes Enlarged character command Input Data Formats Print command Enlarged character cancel commandPaper feed command Clear command Buzzer Command Initial Set CommandInverted character command Underline Command Graphic Command Graphic Type Only Pin 13 1/9 inch Line Feed Pitch Set Command Graphic Type14 2/9 inch Line Feed Pitch Set Command Graphic Type Form Feed Command Skip Perforation Cancel Command 2nd byte 4EH 3rd byte N7 N6 N5 N4 N3 N2 N1 Binary digital Full Cut Command 1st byte Character Code Tables International Character Codes Individual Country Character Codes Exterior MaintenanceMaintenance Procedures Interior External Dimensions CBM-710 CBM-720 Paper Winder Unit AW-2 CBM-730 CBM-750 Information Systems Division Head Office