Chapter3 Preparing the Printer
Installing Roll PaperAuto Cutter and Rewinder Equipped Model
Installation Method1. Pull the rear cover open lever towards | Rear cover open lever |
| |
you to open the rear cover. |
|
2. Then pull the platen open lever | Platen open lever |
| |
towards you to open the platen unit. |
|
Platen unit
3. Set the attached partition in place if the copy roll paper you are using is 69.5mm wide or 57.5mm wide.
Change the paper width by changing the value set as the width using the Soft SW Setting Mode.
Caution
When setting the roll paper, be careful not to cut your hand on the edge of
the paper.
Partition
Location set for width of 57.5mm Location set for width of 69.5mm
30