Chapter4 Maintenance Mode

Maintenance Mode

The settings of the printer can be changed according to its usage environment in maintenance mode. And it is also possible to change their settings back to the initial factory shipping setting or to adjust the cut position after printing in this mode. And the content of the settings can be confirmed in demonstration printing mode.

To change the settings in maintenance mode, print and check the present settings.

Demonstration printing mode

Setting the mode

Turning the power on while pressing the FEED switch with the front cover and the rear cover both closed starts demonstration printing mode and the “demonstration printing and the present printing settings” are printed.

Setting maintenance mode

1. Set maintenance mode by turning on the power while pressing the FEED switch with the front cover open and the rear cover closed, then releasing the FEED switch.

2. The POWER LED flashes as the printer Power switch enters maintenance mode.

Close the front cover in this status.

Front cover open

FEED switch

Flashing

Types of maintenance mode

There are the following four types of maintenance mode.

Each mode is selected according to the number of times the FEED switch is pressed from maintenance mode.

￿HEX Dump Mode: Press the FEED switch 0 times and reopen and close the front cover.

￿Soft SW Setting Mode: Press the FEED switch 1 time and reopen and close the front cover.

￿Initial Factory Shipping Mode: Press the FEED switch 2 times and reopen and close the front cover.

￿Cut Position Adjustment Mode: Press the FEED switch 3 times and reopen and close the front cover.

34