Citizen Systems CT-S300 user manual Printing Paper, Paper Type Product Name

5.Returning to the memory switch select mode

When the setting of the desired content is completed, open the paper cover and then close the paper cover. This allows the printer to print the setting of the changed memory switch.

6.Saving the setting and exiting the memory switch setting mode

Press the FEED switch short to move to “Write/Factory Setting”. Then press and hold the FEED switch. The printer prints the content of new setting and exits the memory switch setting mode to return to the normal standby state.

*Unless saving the setting is executed, the changed setting cannot be enabled.

7.Initializing the memory switch

When you want to return the memory switch setting to the initial state, go to “Write/Factory Setting” in the above procedure. Here, open the paper cover and press and hold the FEED switch till buzzer sounds. This allows the printer to return to the initial state.

*All the memory switches settings are returned to the factory set values.

5.3 Printing Paper

Use the print paper shown in the following table or the paper with equivalent quality.

Paper Type	Product Name
Recommended thermal	TF50KS-E2D from Nippon Paper
paper roll	KF50-HAD, PD150R, PD160R from Ohji Paper
	F220VP, HP220A, F230AA from Mitsubishi Paper

	Paper width 80 −+01			Paper width 58 −+01
4	Maximum print area 72	4	4	Maximum print area 48	6

φ83 or less

Printing surface

ø18 ø12 65~75 ∝m

Unit: mm

CAUTION!

Use the paper with the start of winding to roll core is as shown below.

●No fold line is present and paper is along the inner diameter.

●No turnup is present.

●No pasting to core is present.

●Outer winding (print side out) is used.

— 28 —