Citizen Systems CT-S300 user manual Manual Setting of Memory Switch, Switch No Setting OFF

5.2 Manual Setting of Memory Switch

Memory switches can be set manually or by a command. For manual setting, refer to the next page.

The function of each memory switch is shown in the following table. (The white-on-black characters are factory setting.)

Switch No.	Setting		0 (OFF)				1 (ON)
Memory SW1-1	Power ON Info					Not send
				Send
Memory SW1-2	Buffer Size					45 bytes
			4k bytes
Memory SW1-3	Busy Condition								Full
			Full/Err
Memory SW1-4	Receive Error					No Print
			Print “?”
Memory SW1-5	CR mode								LF
			Ignored
Memory SW1-6	Reserved
				Fixed					−
Memory SW1-7	DSR Signal								Valid
			Invalid
Memory SW1-8	Init Signal								Valid
			Invalid
Memory SW2-1	Reserved
					−			Fixed
Memory SW2-2	Auto Cutter		Invalid
									Valid
Memory SW2-3	Spool Print								Valid
			Invalid
Memory SW2-4	Full Col Print	CBM1000
							EPSON
Memory SW2-5	Resume aft PE								Top
				Next
Memory SW2-6	Paper width		80 mm				58 mm
Memory SW2-7	Reserved
				Fixed					−
Memory SW2-8	NPE Sensor						Invalid
				Valid
Memory SW3-1	Resum Cttr Err					Command
		Feed S/W
Memory SW3-2	Resum Open Err					Command
				Close
Memory SW3-3	Parallel 31 Pin						Invalid
				Valid
Memory SW3-4	Paper Select					Black MK
			Thermal
Memory SW3-5	Column Number					42/30 col
			48/32 col
Memory SW3-6	No use
				Fixed					−
Memory SW3-7	CBM1000 Mode		Invalid						Valid
Memory SW3-8	Open w/Printing			Auto			Manual
Memory SW4-1	Auto Length		Invalid						Valid
Memory SW4-2	BM Sensor		Surface						Back
Memory SW4-3	No use				OFF			Fixed
Memory SW4-4	No use							Fixed
					OFF
Memory SW4-5	No use							Fixed
					OFF
Memory SW4-6	No use							Fixed
					OFF
Memory SW4-7	No use							Fixed
					OFF
Memory SW4-8	Full Cut Cmd		Full Cut
							Partial

— 26 —