Clarion AX430 owner manual In Case Of Difficulty, Error Displays

8. IN CASE OF DIFFICULTY

Problem	Cause	Measure
Power does not turn on.	Fuse is blown.	Replace with a fuse of the same
(or no sound is produced.)		amperage as the old fuse.
	Connections are improper.	Read the attached “Installation/Wire
		Connection Guide” once again and
		wire properly.
Sound quality is poor.	Playback head is dirty.	Use a cleaning tape, etc. to clean the
		head.
No sound while unit can	Power ANT lead is shorted	Turn the unit off, first.
be operated.	to the ground.	Remove all connecting wires from the
		power ANT lead, and turn the unit on,
		then re-connect a wire one by one to
		the power ANT lead.
		When sound is muted again, check
		the unit with a wire connected last.

9. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.

Take the measures described below to eliminate the problem.

	Error Display	Cause	Measure
	ERROR 1	Tape cannot be played due to defective	Eject the tape then replace it with a new
		tape such as cut tape.	one.
Tape	ERROR 2	Tape is caught and cannot be played.	Remove the caught or wound tape.
	ERROR 4	Tape mode cannot be detected.	This is a failure of tape mechanism and
			consult your store of purchase.
	ERROR 8	Tape is caught and cannot be ejected.	Eliminate the reason for which the tape
			is caught.
	ERROR 2	A CD inside the CD changer is not	This is a failure of CD changer’s mecha-
changer		loaded.	nism and consult your store of pur-
			chase.
	ERROR 3	A CD inside the CD changer cannot be	Replace with a non-scratched, non-
		played due to scratches, etc.	warped disc.
CD
	ERROR 6	A CD inside the CD changer cannot be	Eject the disc then reload it properly.
		played because it is loaded upside-
		down.

If a display other than one of the displays above appears, press the reset button. If the problem per- sists, turn the power off and contact your store of purchase.

AX430 13