7. OPERATION
Note:
•Be sure to read this chapter referring to the front diagrams of chapter “2. CONTROLS” on page 3 (unfold).
Basic Operation
CAUTION
When this unit is turned on, starting and stop- ping the engine of a car with its volume raised to the maximum level may harm your hearing.
Be careful about adjusting the volume.
1)Press the [FNC] button.
*To turn the power off, press the [FNC] button for at least 1 second.
2)Press the [FNC] button to select the opera- tion mode. The mode switches as follows each time the [FNC] button is pressed:
Radio ➜ Tape ➜ CD changer ➜ Radio
Adjusting the Treble
1)Press
2)Turning the [ROTARY] knob clockwise empha- sizes the treble; turning it counterclockwise at- tenuates the treble.
*The factory default setting is “0”. (Adjustment range:
3)When the adjustment is complete, press
Adjusting the Balance
1) Press
*If a component is not connected, that opera- tion mode cannot be selected.
*“CASS” appears when no tape is loaded in the source unit, and “DISC” appears when no disc is loaded in the CD changer.
3)Turning the [ROTARY] knob clockwise in- creases the volume; turning it counterclock- wise decreases the volume.
*The volume level is from 0 (minimum) to 33 (maximum).
Audio Mode Adjustments
Press the
BASS ➜ TREB ➜ BAL ➜ FAD ➜ Previous mode
Adjusting the Bass
1)Press
2)Turning the [ROTARY] knob clockwise empha- sizes the bass; turning it counterclockwise at- tenuates the bass.
*The factory default setting is “0”. (Adjustment range:
3)When the adjustment is complete,
8 AX430
2)Turning the [ROTARY] knob clockwise empha- sizes the sound from the right speaker; turn- ing it counterclockwise emphasizes the sound from the left speaker.
*The factory default setting is “0”. (Adjustment range: L9 to R9)
3)When the adjustment is complete, press
Adjusting the Fader
1)Press
2)Turning the [ROTARY] knob clockwise empha- sizes the sound from the front speakers; turn- ing it counterclockwise emphasizes the sound from the rear speakers.
*The factory default setting is “0”. (Adjustment range: F9 to R9)
3)When the adjustment is complete, press
Setting the Z-enhancer
This unit comes with three types of sound tone effects stored in memory. Select the one you pre- fer.
* The factory default setting is
Each time you press