6. CONNECTIONS
Note: Please read this chapter referring to “2. INDENTIFICATION OF PARTS” at the beginning of this manual.
FRONT | 1 | How to make wirings |
REAR |
| |
2 |
| |
| 1. CeNET Cable | |
| 3 | |
FRONT REAR | Orient the CeNET 3 cable in the direction | |
|
| |
4 |
| shown in the figure and insert it until it is locked |
|
| in position. To remove the CeNET cable, pull |
|
| it by lightly grasping the slide cap A in your |
|
| fingers. |
DPH910 | 6 |
|
|
|
5
1RCA cable (2)
Connect it to the source unit’s front input ter- minals (gray) to use the source unit’s
2RCA cable (2)
Connect it to the source unit’s rear input ter- minals (black) to use the source unit’s
3RCA extension cable (sold separately) Connect it to the subwoofer amplifier.
4CeNET cable (3)
Connect it to the source unit, CD changer or MD changer.
5Digital optical fiber cable (sold separately)
Connect it to the source unit, CD changer or MD changer.
6Ground lead (4)
Connect it to vehicle chassis ground.
CAUTION
•Wire the CeNET cable so that there is mini- mal tension in the cable, and the connec- tion part will not come off.
•To extend the CeNET cable, use either CCA- 520 (98.4˝/2.5m) or
2. RCA Cable
Attach the supplied name plate 2on the RCA cable to show where to connect it. After check- ing where to connect it from the name plate, connect the RCA cable.
F
RONT
CAUTION
•Do not remove the insulating cap of the RCA cable that is not to be connected, to prevent
•Fix the connection part of the RCA cable with insulating tape B so that it will not come loose and disconnect.
DPH910 11