5.INSTALLATION
1.Before starting, be sure to disconnect the battery’s negative “−” terminal to prevent ac- cidents due to
2.Location
Consider safety and operability when select- ing a place for installation. Avoid the following.
• Locations where the unit will hamper driving.
• Locations where the unit could injure passen- gers if the car stops suddenly.
• Locations exposed to direct sunlight or hot air from the heater, etc.
• Locations where the unit may be exposed to rain or water.
3.Be sure to use the included screws and brack- ets. Screws other than those supplied could damage the unit.
CaseCase
Damage
8mm max.
4.When drilling holes in the dashboard, etc., be sure to check beforehand that there are no harnesses or other wires on the inside.
Installation example (Installing the unit under the driver’s seat)
Note: Please read this chapter referring to “2. INDENTIFICATION OF PARTS” at the beginning of this manual.
1. Attach the mounting brackets 5 to the sides of the DPH910 using the screws 8 provided.
2. Select the location on the floor mat. Drill holes in the floor mat to match the positions of the holes in the mounting brackets 5.
3. Insert the canoe clips 7 from the rear of the floor mat and install the DPH910.
∗ There are three mounting holes on each side of the DPH910. Select the appropriate holes to match to the installation location.
10 DPH910
