APX_DPX Amps.qxd 2/6/2008 11:53 AM Page 19
DPX1851 and DPX11551 stackable configurations
In this mode, the master amp’s
For example, setting the crossover frequency on the master sets it on all slaves. This works for all
Multiple amplifiers can be
The following describes the configuration of the amplifiers:
Master | • Route input from the head into the normal mode inputs. |
| • Set the master/slave switch to Master. |
| • Route a single RCA cable from the Slave Out to first slave unit. |
|
|
First slave | • Set the master/slave switch to Slave. |
| • Route a single RCA cable from the master Slave Out to the |
| current amplifier’s Slave In. |
|
|
Additional slave(s) • Set the master/slave switch to Slave.
•Route a single RCA cable from the previous amplifier’s Slave Out to the current amplifier’s Slave In.
Each amplifier can independently control separate speaker loads (assuming the phase switch on all amplifiers is set the same).
Or, to power a large single load (phase switch opposite on the amplifier), you can bridge across the amplifiers: + and + to load, - and - to each other. The master amp is “speaker +” for
Any pair of amplifiers could also be bridged, but be careful to set the phase switches correctly.
Setting the gain
After completing the installation, follow these steps to set the gain control and per- form the final system checks.
1.Turn the gain control all the way down (counterclockwise).
2.Select the proper input voltage range using the IVS. See “Selecting Input Voltage” in the “Operations” section of this manual.
3.Turn the vehicle’s ignition switch on.
4.Turn the audio system on with the volume turned all the way down.
5.Set all tone or equalization controls to flat positions and turn loudness off.
6.Play a CD and turn the volume up on the head unit until you hear distortion. This should be most of the way up.
English
19