Operations Common to Each Mode
English
∗This setting item can be adjusted within the range SPEED 1 to SPEED 6.
Adjust this setting item while viewing how the appearance of the display changes.
●Dimmer level
You can adjust the reduced illumination level of the dimmer.
∗The factory default setting is “LV3”. (Adjustment range is LV1 to LV5)
●LV1 to LV5:
The dimmer operation is performed depending on the set level LV1 to LV5.
●OFF:
No dimmer operation is performed.
●Adjusting the display contrast
You can adjust the display contrast to match the angle of installation of the unit.
∗The factory default setting is “08”. (Adjustment level: 01 to 16)
●Setting the Subwoofer
You can set the subwoofer on or off.
∗The factory default setting is “ON”.
●Setting LOW PASS FILTER
∗The factory default setting is “THROUGH”.
∗If subwoofer function is set “ON”, “LOW PASS FILTER” can be selected.
THROUGH ➜ 50 ➜ 80 ➜ 120
●Setting the external amplifier
∗The factory default setting is “OFF”.
To change other settings
1.Press the [ADJ] button to switch to the adjustment selection display.
2.Press the [a, d] lever upward or downward to select the “item name”. Each time the [a, d] lever is pressed up/ down, the item display changes in the following order:
“BLINK LED” ↔
3.Turn the [ROTARY] knob to select the “desired setting item”.
∗ After completing settings, press the [ADJ] button to return to the previous mode.
●
The red
∗The factory default setting is “OFF”.
• ON:
Use with connected AMP.
• OFF:
Use with inside AMP.
●Selecting AUX IN sensitivity
Make the following settings to select the sensitivity when sounds from external devices connected to this unit are difficult to hear even after adjusting the volume.
∗The factory default setting is “MID”.
●Performing a system check
This function allows you to perform a system check from the adjust mode when required.
“SYSTEM CHECK” appears in the display, then the unit returns to the previous operation mode.
22 DXZ655MP