Clarion DXZ675USB owner manual Operations Common to Each Mode, To change adjustment setting

Operations Common to Each Mode

English

To change adjustment setting

1.Press and hold the [OPTION] button for 1 second or longer to switch to the adjustment selection display.

2.Push the [SEEK PANEL] leftward or rightward to select the “item name”.

“CLOCK EDIT” ↔ “CONTRAST” ↔

“SCREEN SAVER” ↔ “MSG INPUT” ↔ “AUTO SCROLL” ↔ “SCROLL SPEED”’ ↔ “DIMMER” ↔ “BLINK LED” ↔ “AMP CANCEL” ↔ “TEL-SPEAKER”↔ “TEL- SWITCH” ↔ “SYSTEM CHECK”

3.Push the [P.CH] button upward or downward to select the “desired setting value”.

∗ In the case of display appearing “ENT”, the

[ ] button must be pressed to display the setting value.

∗ After completing settings, press the [OPTION] button to return to the previous mode.

●Setting the clock

2-1.	Select “CLOCK EDIT”.
3-1.	Press the [	] button

3-2. Push the [SEEK PANEL] leftward or rightward to select the hour or the minute.

3-3. Push the [P.CH] button upward or downward to set the correct time.

∗The clock is displayed in 12-hour format.

3-4. Press the [	] button to store the
time into memory.

Note:

•You cannot set the clock when it is displayed with only the ignition on. If you drain or remove the car’s battery or take out this unit, the clock is reset. While setting the clock, if another button or operation is selected, the clock set mode is canceled.

●Setting the contrast

You can adjust the display contrast to match the angle of installation of the unit.

∗The factory default setting is “8”. (Adjustment level: 1 to 16)

2-1. Select “CONTRAST”.

3-1. Push the [P.CH] button upward or downward to adjust the contrast.

●Turning the screen saver function on

or off

This unit is provided with the screen saver function which allows you to show various kinds of patterns and characters in the operation status indication area of the display in a random order. You can turn on or off this function. If the button operation is performed with the screen saver function on, the operation display corresponding to the button operation is shown for about 30 seconds and the display returns to the screen saver display.

∗The factory default setting is “Pattern RANDOM”.

2-1.	Select “SCREEN SAVER”.
3-1.	Press the [	] button.

3-2. Push the [P.CH] button upward or downward to select the setting.

“Pattern RANDOM” ↔ “Pattern

MESSAGE” ↔ “Pattern SS” ↔ “Pattern

OFF”

3-3. Press the [	] button to return to the
previous mode.

●Entering message information

Message up to 30 characters long can be stored in memory and displayed as a type of screen saver setting.

∗The factory default setting is “Welcome to Clarion”.

2-1.	Select “MSG INPUT”.
3-1.	Press the [	] button.

3-2. Press and hold the [MENU] button for 1 second or longer to clear the old message.

3-3. Push the [SEEK PANEL] leftward or rightward to move the cursor.

20 DXZ675USB