Clarion DXZ735MP owner manual In Case Of Difficulty, Error Displays, English

English

9. IN CASE OF DIFFICULTY

	Problem	Cause	Measure
	Power does not	Fuse is blown.	Replace with a fuse of the same amperage. If the
	turn on.		fuse blows again, consult your store of purchase.
	(No sound is
	produced.)	Incorrect wiring.	Consult your store of purchase.
	No sound output	Power antenna lead is	1. Turn the unit off.
	when operating	shorted to ground or	2. Remove all wires attached to the power antenna
	the unit with	excessive current is required	lead. Check each wire for a possible short to
	amplifiers or	for remote-on the amplifiers	ground using an ohm meter.
	power antenna	or power antenna.	3. Turn the unit back on.
	attached.		4. Reconnect each amplifier remote wire to the
			power antenna lead one by one. If the amplifiers
			turn off before all wires are attached, use an
			external relay to provide remote-on voltage
General			(excessive current required).
	pressed.	etc.	move the DCP.
	Nothing happens	The microprocessor has	Turn off the power, then press	Reset button
	when buttons are	malfunctioned due to noise,	the [OPEN] button and re-
			Press the reset button for
	Display is not		about 2 seconds with a thin
	accurate.		rod.
		DCP or main unit connectors	Wipe the dirt off with a soft cloth moistened with
		are dirty.	cleaning alcohol.
	No sound heard	The speaker protection	1. Turn down sound volume. Function can also be
		circuit is operating.	restored by turning the power off and on again.
			(Speaker volume is reduced automatically when
			the speaker protection circuit operates).
			2. If the sound is muted again, consult our service
			department.
	No sound heard	MP3/WMA files are absent in	Write MP3/WMA files onto the disc properly.
		a disc.
		Files are not recognized as	Use MP3/WMA files encoded properly.
		an MP3/WMA file.
		File system is not correct.	Use ISO9660 level 1, 2, 3 or JOLIET or Romeo file system.
	Sound skips or is	Compact disc is dirty.	Clean the compact disc with a soft cloth.
	noisy.
		Compact disc is heavily	Replace with a compact disc with no scratches.
CD/MP3/WMA		scratched or warped.
	Sound is cut or	MP3/WMA files are not	Use MP3/WMA files encoded properly.
	skipped.	encoded properly.
	Noise is
	generated or
	noise is mixed
	with sound.
	Sound is bad	Water droplets may form on	Let dry for about 1 hour with the power on.
	directly after	the internal lens when the
	power is turned	car is parked in a humid
	on.	place.
	Wrong filename	File system is not correct.	Use ISO9660 level 1, 2, 3 or JOLIET or Romeo file system.
	Play list play is	File name or extension is not	Use alphanumeric/ASCII characters for MP3/WMA file name.
	not performed.	correct.	Use “.M3U” or “.ASX” for the file extension of a play list.

10. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.

Take the measures described below to eliminate the problem.

	Error Display	Cause	Measure
	ERROR 2	A CD is caught inside the CD deck and is	This is a failure of CD deck’s mechanism
		not ejected.	and consult your store of purchase.
CD/MP3/WMA
	ERROR 3	A CD cannot be played due to scratches,	Replace with a non-scratched,
		etc.	non-warped-disc.
	ERROR 6	A CD is loaded upside-down inside the	Eject the disc then reload it properly.
		CD deck and does not play.
	ERROR 2	A CD inside the CD changer is not	This is a failure of CD changer’s
		loaded.	mechanism and consult your store of
changer			purchase.
	ERROR 3	A CD inside the CD changer cannot be	Replace with a non-scratched, non-
CD		played due to scratches, etc.	warped disc.
	ERROR 6	A CD inside the CD changer cannot be	Eject the disc then reload it properly.
		played because it is loaded upside-down.
	ERROR H	Displayed when the temperature in the	Lower the surrounding temperature and
		MD changer is too high and playback has	wait for a while to cool off MD changer.
		been stopped automatically.
	ERROR 2	An MD inside the MD changer is not	This is a failure of MD changer’s
		loaded.	mechanism and consult your store of
changer			purchase.
	ERROR 3	An MD inside the MD changer cannot be	Replace with a non-scratched, non-
MD
		played due to scratches, etc.	warped disc.
	ERROR 6	An MD inside the MD changer cannot be	Eject the disc then reload it properly.
		played because it is loaded upside-down.
		Displayed when a non-recorded MD is	Load a pre-recorded MD in the MD
		loaded in the MD changer.	changer.

English

28 DXZ735MP DXZ735MP 29