Problem:
Midrange speakers “pop” with loud passages.
Solution:
Gain Controls on amplifiers are set incorrectly. Reduce the gain setting on high frequency amplifier.
Problem:
One channel does not operate.
Solution:
Swap left and right connections at the source unit. If the problem trades sides in the vehicle, then the source unit is the defective. If the problem stays on the same side, proceed on.
Swap left and right connections at the input to the crossover. If the problem trades sides in the vehicle, then the wiring is defective between the source unit and the crossover. If the problem stays on the same side, proceed on.
Swap the left and right
Swap the left and right
Swap the left and right speaker connections at the output of the
Problem:
Green power indicator LED not on, there is no sound.
Solution:
Check the CONSTANT and REMOTE (Switched) wiring connections.
Check the GROUND wiring for good connections.
PRODUCT SPECS
Power Source: | 14.4 volts DC negative ground |
Input current: | 0.5 amp max |
Disortion: | 0.01% THD at 1V output level |
Frequency Response: | 10Hz - 30kHz - 3dB |
S/N Ratio: | >100dB |
Separation: | 60dB |
Crossover Slope Rate: | 18dB per octave 3rd order butterworth |
Input Impedance: | 20K Ohms |
Output Impedance: | 100 Ohms |
Output Gain: | 1:2(+6db) |
Output Voltage level: | 5 volts max |
Dimensions: | 152mm x 180mm x 43mm |
15