Clarion VMA6492 6.4Ó TFT LCD Monitor, STAND ALONE SYSTEM With TTX001 and WH100/WH200

APPLICATIONS

VMA6492 6.4Ó TFT LCD Monitor

er. Connect the other jack end of the Y-connector into the IR extension cable coming from the VMA6492 monitor.

5.Plug the video RCA from the VMA6492 into the LINE OUT video connec- tion on the rear of the player. Plug the provided audio RCA cable into the L/R LINE OUT audio connections. Connect the power wires from the VMA6492, TTX001, and the power wires of the VDH9600 together.

6.Remove the vehicle’s radio. Run both the audio RCAs and power wires to the radio location and plug the audio RCAs into the FM100S audio inputs.

7.Mount the switch for the FM100S and run its’ power wire to the radio loca- tion. The power wires of the TTX001, video player, VMA6492 and the FM100S can be joined and connected to the radio accessory and battery wires.

8.Plug the vehicle antenna into the antenna input of the FM100S. Plug the antenna output of the FM100S into the radio.

9.The FM100S has a two position switch used to select the modulation frequen- cy (88.7 or 89.1 Mhz). Pick the frequency that won’t interfere with reception of other radio stations. Set that frequency into the radio’s preset memory.

OPERATION: (With the VDH9600, TTX001 and the FM100S)

1. Turn the vehicle ignition switch to the accessory (ACC) position.

NOTE: Since all IR signals are linked together; point any remote control at the SEN- SOR eye (located on the front of the VMA6492) to activate its’ component.

2.Press POWER on the player’s remote control to turn the video player ON.

3.Press POWER on the RC-300 remote control to turn the TTX001 TV tuner ON. The TV picture is displayed on the monitor.

NOTE: The VDH9600 automatically loops its A/V inputs through to its A/V outputs, the video signals from the TTX001 passes through to the VMA6492.

4.Toggle the FM100S’s switch to the ON position and tune the radio to the modulated frequency. Adjust the vehicle’s sound system to a comfortable level.

5.Insert a VHS tape into the VDH9600 player and the VMA6492 monitor will now display the player’s video and audio signals.

STAND ALONE SYSTEM: (With TTX001 and WH100/WH200)

1.Pick a location to mount the TTX001 TV tuner. Avoid areas with excessive heat or moisture. Plug the 16-pin A/V Output connector into the TTX001 tuner.

2.Mount the TV antenna (ZCB-303 or equivalent) and plug it into the TTX001 antenna input connector.

3.Once a location has been determined for the VMA6492, run the 3.5 mm IR extension, video RCA and 2-pin Power Molex connector into the monitor’s

6