Clarion VMA6492 owner manual Ownerõs Manual, Fuse is blown

RGB Input Level:

0.75 volts peak to peak, TTL

Video Input Level (RCA): 1.0 volts peak to peak, NTSC

224,640 Dots

Screen Resolution:

960 x 234

Pixels:

6.4” (Panel Dimensions 113 x 85mm)

Screen Size:

Color TFT Active Matrix LCD

Display Type:

MONITOR SPECIFICATIONS:

2-pin Molex Power connector

Video RCA cable (5 Meters)

Supplied Accessories:

(188 x 130 x 31 mm)

7-3/8 x 5-1/8 x 1-1/4 in.

1.1 lb (0.5 kg)

Weight:

Dimensions (w x h x d):

3.5mm Male to Male IR extension cablePUTTITLE(5 Meters) HERE

0.58 amps (58 mA)

+12 volts dc (9-16 volts dc)

7 watts, Power On

Power Requirement:

Power Consumption:

SPECIFICATIONS:

GENERAL SPECIFICATIONS:

Symptom

System does not work.

The picture has shadows when con- nected to the TTX001.

The picture has stripes or spots when connected to the TTX001.

The screen is dark.

No picture on mon- itor.

TROUBLESHOOTING:

	OWNERÕS MANUAL
Cause	Solution
Fuse is blown.	Replace external fuse with the same
Power wires are not	value.
	Check the wire connections and con-
connected.	nect it properly.
The signal condi-	This may due to signals reflected off
tion is poor.	buildings, mountains, etc. Check
	again in a different place and direc-
	tion.
There may be inter-	This may due to signal interference
ference signals.	from other cars, high voltage lines,
	neon lights, etc. Check again in
	another place.
The brightness is	Check that the brightness is properly
adjusted too low.	adjusted and set it properly.
Usage conditions	This may happen if the temperature
are poor.	in the vehicle is below 30°F or above
	113°F. Check again when the tem-
	perature is between 30 and 113°F.

The TV tuner is not set to TV mode (using the TTX001) The TV tuner is set to VTR mode.

Set the TV Tuner function to “TV” mode.

In the VTR mode, no picture appears if no video signal is being input to the VIDEO IN terminal of the tuner.

TROUBLESHOOTING

9