1.Disconnect the negative
2.Find a place in the vehicle for the video source(s).
3.Create passage holes for the power and video cables.
When drilling through metal or plastic, use grommets to protect the cables from sharp edges that could penetrate the insulation and cause a short circuit and device failure.
4.Connect the ground lead (black) securely to a clean metal plate on the vehicle.
Use sand paper to remove any paint from the surface where you attach the ground terminal.
5.Reconnect the negative
CAUTION ! Some
IR connector polarity:
PLASTIC COVER
IR DATA LINE
This 3.5mm IR Jack has plastic cover to prevent short, to remove the plastic cover, please do not pull it out directly, please rotate the plastic cover and put it out slowly.
English
15