Installation
•Notes:
-Choose the mounting location where the unit will not interfere with the normal driving function of the driver.
-Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly.
-Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
-Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
-Install the unit where it does not get in the driver's way and cannot injure passengers if there is a sudden stop, like an emergency stop.
-If the installation angle exceeds 30° from horizontal, the unit might not give optimum performance.
-Avoid installing the unit where it will be subject to high temperature, such as from the heater, or where it will be subject to dust, dirt or excessive vibration.
•DIN Front/Rear-mount
This unit can be properly installed either from the “Front” (conventional DIN
- DIN Front-mount (Method A)
Installing the unit
1.Dashboard
2.Holder
After inserting the holder into the dashboard, select the appropriate tabs according to the thickness of the dashboard material and bend them inwards to secure the holder in place.
1.Dashboard
2.Hex nut (M5)
3.Spring washer
4.Hex washer head tapping screw (M5⋅18)
5.Strap
Be sure to use the strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle.
6.Plain washer
6
