6. Cautions on Wiring
1.Be sure to turn the power off before wiring.
2.Be particularly careful where you route the wires. Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
3.If the fuse should blow, check to see if the wiring is correct.
If a fuse is blown, replace it with a new one of
the same amperage rating as the original (15A FUSE).
4.To replace the fuse, remove the old fuse on the back of the unit and insert the new one. (Figure 8)
NOTE:
There are various types of fuse holder. Do not let the battery side touch other metal parts.
caution
CAUTION
After the connection, fix the cord by a clamp or insulation tape for protection.
Fuse (15A FUSE)
Fuse holder 
Figure88
EnglishEnglish
Manual Owner’s
VX401/VZ401 51