Clarity manual XLC2 Installation

XLC2 Installation

Connect your telephone as shown on the enclosed Quick Start guide.

Your telephone should arrive pre-assembled. To install it:

1.Remove base from package.

2.Hold one end of your XLC2’s long phone line cord tightly. The correct end to hold should already be plugged into your phone’s jack. Simultaneously pull the other end of the phone cord away from the phone, unraveling it and allowing you to plug that end of the cord into a wall telephone outlet.

3.Plug the loose end of the phone cord into the wall telephone outlet.

4.Hold one end of your phone’s white power adapter cord tightly.The correct end to hold should already be plugged into the back of your telephone base unit. Simultaneously pull the other end of the adapter cord away from the phone, unraveling it and allowing you to plug that end of the cord into a wall electrical outlet.

5.Plug white power adapter cord on left rear of the base into a wall electrical outlet.

6.Remove handset from package.

7.Pull the handset’s battery tab located on the bottom of the device in the direction of the arrow.

8.Place the handset in the base charger.The batteries in the handset must be fully charged for 10 hours before using the telephone for the first time.

9.Lift handset and press TALK to test. If you hear a dial tone, your telephone is ready for use. If not, check all connections again.

XLC2 Installation

E

N G L I S H

8 9