Your CLASSÉ CAM200 power amplifier is packed in high density, semi-rigid foam placed
in a special cardboard box. Take it out of the plastic bag and inspect the unit for any concealed
damage. Apart from this owner's manual, please ensure the following has also been included:
1) Detachable A.C. linecord
Please report any damage or missing parts to your dealer immediately.
Place the CAM200 at or near its final set-up position, allowing 8 inches at the rear for
tightening the speaker output connectors. For optimum sonic performance, we recommend the
optional CLASSÉ REFERENCE A.C.
. Consult your dealer regarding this accessory.
The power transformer in the CAM200 is located at the front center of the unit. Ideally, a
few feet should separate this area from components which are potentially could pick up hum. These
include preamplifiers, turntables, and interconnect cables. In terms of providing adequate airspace
for cooling, a good rule of thumb is to allow 6 inches above and 3 inches on each side of the unit.
Check the Serial Number sticker on the back of the unit for the correct operating voltage.
The CAM200 has one external AC fuse, the rating of which should be as follows:
LINE VOLTAGE FUSE RATING
100 or 120 V.A.C10 AMP SLOW-BLOW 125 or 250 volts
220 or 240 V.A.C 8 AMP SLOW-BLOW 250 volts
GENERAL CONNECTIONS
A.C. LINE
4