Classe Audio CAV-75 General Connections and Operation, Line, Normal Operation, Bridged Operation

4 AMP FAST BLOW 125 volts

INTERNAL RAIL FUSES:

The CAV-75 is designed with each channel protected by one pair of internal fuses for positive and negative rails (see fig-1 page 7)

GENERAL CONNECTIONS AND OPERATION:

A.C. LINE

Insert the linecord into the A.C. receptacle on the rear of the unit.

CAUTION: SAFETY INSTRUCTIONS

DISCONNECT AC LINE CABLE WHILE MAKING ALL CONNECTIONS. "FLOATING THE GROUND", OR DEFEATING THE GROUND ON A 3-PRONG LINECORD MAY CREATE A SHOCK HAZARD. CONNECT ALL INTERCONNECT CABLES BETWEEN THE ELECTRONICS BEFORE CONNECTING THE A.C. LINECORDS TO THE WALL OUTLETS. THIS WILL REDUCE THE POTENTIAL SHOCK HAZARD. SEE ALSO THE WARRANTY SECTION OF THIS OWNER'S MANUAL.

NORMAL OPERATION:

Input and output connectors for each channel are clearly grouped and marked on the back of the amplifier. (Units are preset at the factory for NORMAL.) See fig.3a,3b for typical connections of the CAV-75.

Use only high quality interconnect and loudspeaker cables, and make all connections tight. If the input plugs are loose, remove them and pinch down the ground leaves slightly with pliers. Observe correct phasing of the loudspeaker connections, and tighten.

BRIDGED OPERATION:

- 5 -