ClearSounds user manual Set up Features, A50 Handset, Battery Life, Belt Clip Installation

Battery Life

Fully charged batteries provided an average talk time of about 4 hours, or standby time of about 8 days. Talk time & standby time may vary depending on operating conditions.

The life of the NiMH battery is more than one (1) year.

Belt Clip Installation

You may choose to use the optional belt clip provided with your handset (See diagram #7).

(Diagram #7) – Install and remove the belt clip

1.To attach, slide the belt clip down onto the grooves. Press the tabs on the belt clip into the slots to attach.

2.To remove, lift one side of the belt clip with your thumbnail and push back.

Set up Features

A50 Handset

You will need to wait 24 hours after initial charging before setting up any features listed below.

Handset Registration
1.	Make sure the base unit is connected into the AC outlet and phone jack.
2.	Press and hold the	/PAGE button on the base unit. After 3 seconds, press
	the “CH” button on the handset, and the unit will give a confirmation beep, which
	means that the code has been set and the handset will show HS-1(Handset 1)
	on the LCD.

3.If you have more than one handset, press the “CH” button on the handset until you get a beep and the display reads HS-2. Continue the same procedure if you have a third handset. If not, release the /PAGE button from the base.

NOTE: The /PAGE button on the base unit should be kept pressed during the whole procedure.

12