ClearSounds user manual Addendum A50 HANDSET REGISTRATION

Addendum

A50 HANDSET REGISTRATION

1Begin with handsets fully charged for 24 hours. Remove all handsets from the charging bases, bringing all of them to the main base and setting them on the counter right next to the main charging base. (The handsets cannot be registered while they are in the charging base). Get ready for this 2-handed process.

2Put your one finger on the PAGE button on the main base. Very important - - You must hold this button down during the whole registration process for all involved handsets without lifting it off. If the button is released, you must start over.

3At the same time - - with your other hand, press and hold the "CH" button on the 1st handset until you hear 2 quick confirmation beeps.

4Immediately move your hand to the next handset – without lifting the PAGE button, press and hold the "CH" button on the 2nd handset until you hear 2 quick confirmation beeps. (Repeat for 3rd handset if applicable – without lifting the PAGE button).

5Release your hand from the PAGE button now on the main charging base.

6Handset 1 should now show "HS-1" on the display. Handset 2 should now show "HS-2" on the display. (If you have a 3rd Handset, it will now show “HS-3”).

7You should now have a dial tone on all the handsets.

NOTE:

If any handset loses registration, then this process must be repeated for all handsets in order to bring all handsets back into registration.