There is a red light that continues to flash
1.You have
2.Your Voice Mail account needs to be
Difficulty storing numbers in memory
1.Make sure you are pressing the correct sequence of buttons for storing numbers.
2.If you are interrupted by the telephone company’s recorded announcement telling you to hang up or by a loud buzzing noise, ignore and continue to store the num- bers. Or hang up and store the number without lifting the handset or temporarily disconnect the telephone line until you have programmed in all the numbers.
No numbers dialed when memory button is pressed
1.No number stored in that memory button.
2.Make sure phone number was programmed and saved in the memory (See pages
3.Make sure programming is done in the correct dial mode
4.If your phone has been disconnected for a few hours the numbers stored will be lost.
Emergency Connect button doesn’t seem to work when pressed
1.There may be a phone off the hook somewhere in your home. Check that all phones in your home are hung up.
2.Check the Auto On Hook Feature (See page 20).
3.The remote band’s battery is dead or is not installed properly. Check the remote band battery (See page 37).
4.Check the antenna on base.
Caller ID information does not show
1.Make sure you are subscribed to Caller ID through your local phone company.
2.Check batteries.
No Caller ID information while on a call
1.Make sure your service provides Caller ID Information while you are on a call. This is sometimes known as “Caller ID on Call Waiting” or “Type II Caller ID”.
2.Make sure you have the Caller ID – Caller Waiting feature on this phone set to ON
(See page 29).
3.The phone cannot display the information if another phone on the same line is in use. Make sure all extensions are on hook.
Cannot dial out of Caller ID
1.Make sure you are subscribed to Caller ID through your local phone company.
2.Make sure your area code is set up properly (See pages
36
