Cleveland Range 22CET3A

d. Complete the installation of the steamer in accordance with the remaining instructions of this

manual. Once the unit has been leveled using the adjustable feet provided on the stand, it is

recommended that the unit be secured to the floor using the two Anchorable legs.

3. Installation of Cleveland Range SteamChef¥ 3 Steamers on the Model No. ES222824S

Stacking Stand

The Cleveland Range Model ES222824S Stacking Stand includes the stand and all the necessary

hardware to connect the two units plumbing into a common drain outlet and a common set of water

inlets.

a. Beginning Installation of the Cleveland Range Model No. ES222824S Stacking Stand

1). Move the stacking stand base (Item 1, Figure 4-4) to the selected location. We recommend

that the feet with round mounting pads be at the rear of the steamer.

b. Mount the lower unit to the stand base

2). Remove the side panels of the lower steamer and set it into place on the Stacking Stand

base (Item 1, Figure 4-4).

3). Mount the lower unit to the stand from below using the 1/2 x 0.750 lg. bolts and the fender

and locking washers provided installed into both rear leg mounts as shown (See Figure 4-4).

4). Seal any gaps between the stand and the steamer with suitable RTV sealant (not provided).

c. Install the stand spacer onto the lower unit

5). Set the studded spacers (Figure 4-5 Item 2) on top of the lower unit lengthwise with the

nearer stud on the end towards the front of the steamer. Next set the spacer retainer (Figure

4-5 Item 1) over the studded spacer and the steamer (see Figures 4-4 and 4-5). The studs

from the spacer will go through the corresponding openings in the retainer, and the lower

edges of the retainer will extend over the top of the lower unit (See Figures 4-4 and 4-5).

6). Seal between the lower steamer and the spacer retainer with suitable RTV sealant (not

provided).

Figure 4-4 Installing Lower Unit Figure 4-5 Positioning the

Studded Spacer