Clover Electronics CDR0850 What to do at the time of Installation

What to do at the time of

Stand-alone DVR should be installed in the following order;

1. Make sure all the required hardware is available.

- Stand-alone DVR unit (including HDD)

- Up to 8 cameras (including power source)

- CCTV or VGA monitor (or TV set)

- Network cable if connecting to a PC

2. Connect the cameras, the DVR unit and monitor (Refer to [Fig 5-3]).

4. Confirm live video is displayed on the monitor before going to the next step.

5. Select the Setup Menu and set current date and time (Refer to Section 7-2.1).

6. Run the FACTORY DEFAULT setting in the SYSTEM menu.

7. Perform HDD formatting.

8. Escape from Setup Menu.

9. Set values for required options.

10. Network cable should be connected to the DVR unit before turning the power on.

Refer to [Fig 5-11] for the cable specification.