7. Setup
83
7-2.4. IR REMOTE ID
Up to 16 DVR systems can be controlled by only one remote controller we provided, but IDs
should be assigned on each of the systems. You don’t have to assign any ID on the single
unit and you can control the system with the provided remote controller without IR REMOTE
ID, which is in the OFF mode (Skip this section).
▫ Click the IR REMOTE ID button and select one among OFF, 1 through 16 to assign an ID
on the system by clicking the mouse.
[Fig.7-18 IR REMOTE ID button]
▫ When an IR Remote ID is assigned on the system, click the “FREEZE” button and then on
the remote controller, click the same channel button as assigned ID on the system to
match the IDs between the system and the remote controller.
When the FREEZE button and the channel button are pressed on the remote controller,
- if the channel button is identical to the assigned ID, the DETECT IR ID as shown in Fig.7-
19 will be displayed along with the IR ID number.
- if not, the IR ID DENIED as shown in Fig.7-20 will be displayed along with the IR ID
number.
DVR IR ID
NUMBER
Fig.7-19 DETECT IR ID Message
DVR IR ID
NUMBER
Fig.7-20 IR ID DENIED Message