Board Installation
Use the following steps to install the card in the openGearTM 8310 frame:
1. Refer to the Owner’s Manual of the openGearTM 8310 frame to ensure that the frame
|
| is properly installed according to instructions. | |
|
|
|
|
|
| Heat and power distribution requirements within a frame may dictate |
|
|
| specific slot placement of cards. Cards with many |
|
|
| components should be arranged to avoid areas of excess heat |
|
Warning |
| particularly in frames using convection cooling. |
|
|
|
| |
|
| 2. After selecting the desired frame installation slot, hold the card by the edges and | |
|
| carefully align the card edges with the slots in the frame. Then, fully insert the card | |
|
| into the frame until the rear connection plugs are properly seated on the midplane and | |
|
| rear modules. | |
|
| 3. Connect the input and output cables according to the diagram for the rear module | |
|
| being used. The inputs are internally terminated with 75 Ohms. It is not necessary to | |
|
| terminate unused outputs. | |
| This completes the procedure for installing the card in the openGearTM 8310 frame. | ||
9011 Owner’s Manual • (V 1.0) | Page 13 of 22 |
