Cobalt Networks 9034-SD owner manual Board Installation

Board Installation

Use the following steps to install the card in the openGearTM 8310 frame:

1. Refer to the Owner’s Manual of the openGearTM 8310 frame to ensure that the frame

		is properly installed according to instructions.
		Heat and power distribution requirements within a frame may dictate
		specific slot placement of cards. Cards with many heat-producing
		components should be arranged to avoid areas of excess heat build-up,
Warning		particularly in frames using convection cooling.
		2. After selecting the desired frame installation slot, hold the card by the edges and
		carefully align the card edges with the slots in the frame. Then, fully insert the card
		into the frame until the rear connection plugs are properly seated on the midplane and
		rear modules.
	This completes the procedure for installing the card in the openGearTM 8310 frame.

9034-SD Owner’s Manual • (V 2.0) Page 13 of 28