Cobra Electronics 29 WX NW BT specifications Selecting a Channel, To Receive, Meter

Operation Operation

Note

When switched to SWR posi- tion the meter needle should ideally be as far to the left as possible. Anything over 3 is

SWR 2 3 CAL

RF

SIG 1 3 5 7 9 +30dB

VOL SQL

OFF

			29 WX N
S/RF	NB/		CB
	ANL
SWR	ANL
CAL	OFF		PA
DYNA	DIM	RF GAIN
MIN	MAX	MIN	MAX

Selecting A Channel

29 WX NW

N B /	C B	CB	C H 1 9
A N L				RX/TX ANT
A N L			C H 9
				WX
O F F	PA	WX	N O R

M	RF GAIN	WEATHER T BACK		SWR CAL
		3	4
	2		5
	1		6
			7

Selecting A

Channel

Note

Switch to 9 (Emergency) or 19 (Information) for instant access to these channels.

not acceptable. A slight antenna height adjustment (higher or lower) may be required. Repeat recalibration steps.

To Receive

5While still holding down the mic button, set the S/RF SWR CAL switch to the SWR position, to read the SWR reading.

6Repeat the same steps two through five on Channel 1 and 40. This will check SWR for all channels.

To Receive

								29 WX N
SWR	2	3		CAL	S / R F	N B /		C B
						A N L
RF
					S W R	A N L
SIG 1	3	5	7 9	+30dB
								PA
					C A L	O F F
		V O L		S Q L	DYNA	DIM	RF GAIN
	OFF				M I N	MAX	MIN	MAX

1Rotate the On/Off Volume knob clockwise the green RT/TX LED will be illuminated.

MAX MIN MAX

1Switch to NOR to select desired channel.

S-Meter

Swings proportionately to strength of incoming signal when receiving.

SWR	2	3		CAL	S / R F	N B /
RF						A N L
					S W R	A N L
SIG 1	3	5	7 9	+30dB
					C A L	O F F
		VOL		SQL	DYNA	DIM

1The S/RF-SWR-CAL switch must be in the S/RF position to read the meter.

S-Meter

12 13