2QUICK CHECKOUT
Quick Checkout (continued)
To connect your inverter to the power source:
1.Push the inverter’s ON/OFF switch to OFF.
|
| ON/OFF |
AC Output AC Output | POWER | switch |
| FAULT |
|
OFF
ON
2.If the power source is a DC power supply, switch it off.
3.To use the cigarette lighter plug wire:
Connect the wire to the posts on the right side of the inverter. Insert the plug into the cigarette lighter of your vehicle.
To use the direct-to- battery wire:
a.Connect the black cable to the black post marked
b.Connect the red cable to
the red post marked (+) on the back of the CPI 300. Connect the other end to the positive terminal on the battery.
Positive terminal
Negative terminal
4.Plug the power cord from the test load into the inverter’s AC receptacle.
5.Check to be sure all power connections are secure.
CAUTION
A reverse polarity connection (positive to negative) will blow the fuse in the inverter and may permanently damage the unit.
Testing
Turn on the inverter. It should supply power to the load. If the inverter does not appear to work properly, refer to the Troubleshooting Guide on page 7.
| INSTALLATION • OPERATION | |||||||||||||||||||
The location where you install | a 6 volt battery, and will be3 | |||||||||||||||||||
your CPI 300 must be: | damaged if it is connected | |||||||||||||||||||
• | to a 16 volt battery. | |||||||||||||||||||
where water can drip or | Turning on Your | |||||||||||||||||||
splash on it. | Power Inverter | |||||||||||||||||||
• | Turn on your CPI 300 by | |||||||||||||||||||
should be between 30˚ and | ||||||||||||||||||||
pushing the ON/OFF switch | ||||||||||||||||||||
105˚ F (0˚ and 40˚ C). The | ||||||||||||||||||||
to ON. |
|
|
|
|
|
| ||||||||||||||
cooler the better. |
|
|
|
|
|
| ||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
• |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ON/OFF |
|
| ||
1 inch (3 cm) of clearance |
| AC Output AC Output |
|
|
| POWER switch |
|
| ||||||||||||
around the unit for proper |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| FAULT |
|
| ||
air flow. Make sure that |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ON |
|
| ||
ventilation openings on the |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
The unit is now ready to deliver | ||||||||||||||||||||
ends of the unit are not | ||||||||||||||||||||
AC power to your loads. If | ||||||||||||||||||||
obstructed. | ||||||||||||||||||||
several loads are to be powered | ||||||||||||||||||||
|
| |||||||||||||||||||
CAUTION |
| by the inverter, turn them on | ||||||||||||||||||
|
| separately AFTER the inverter | ||||||||||||||||||
To prevent fire, do not cover | ||||||||||||||||||||
has been turned on. This will | ||||||||||||||||||||
or obstruct ventilation | ensure that the inverter will | |||||||||||||||||||
openings. Do not install the | not have to deliver the | |||||||||||||||||||
unit in a | currents required for all loads | |||||||||||||||||||
compartment. Overheating | at once. |
|
|
|
|
|
| |||||||||||||
may result. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The inverter must only be connected to batteries with a nominal output voltage of
12 volts. It will not work with
3 | 4 |