For charging microTALK®radio(s) in desktop
charger:
1. Insert radio(s) into desktop charger as shown.
2.Insert round connector of 120-volt adapter
into jack on back of charger.
3.Plug 120-volt adapter into electrical outlet.
If charging light is not on,check position of radio. Radio should be
upright. The charge indicator light will stay onas long as the radio
is in the charging well.
It normally takes about 15 hours to fully rechargebattery pack.
Battery pack will not be damaged if they stay in the charging well
longer than that.
To charge a single radio, you can bypass the desktop
charger and simply insert the wall adapter’s round
connector directly into the speaker/microphone/charge
jack located on the top of the radio.
Use only the supplied rechargeable batteries and charger for
recharging your Cobra microTALK®radio.
Cobra recommends your radio is turned offwhile being charged.
3
2
Turning on Your microTALK®Radio •
Press and hold the Powerbutton until you
hear a series of audible tones indicating the radio
is on.
Your microTALK®radio is now in Standby
mode, ready to receive transmissions. The radio
is always in Standby mode, except when the
Talk,Call,Modeor Power buttons are pressed.
Battery Low •
When battery power is low, the Battery Lowicon
will blink. Your batteries should be recharged.
Auto Battery Save •
Your microTALK®radio has a unique circuit
designed to extend battery life. If there are
no transmissions for 10 seconds, the radio will
automatically switch to BatterySave mode and
the Power Savericon will flash in the display.
This will not affect the radio’s ability to receive
incoming transmissions.
Communicating with Another Person •
1.Press and hold the Talk button.
2.With the microphone about 2 inches
(5 cm) from your mouth, speak in a
normal voice.
3.Release the Talk button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talkbutton.
Both radios must be tuned to
the same channel/privacy code
to communicate.
Introduction Using Your Radio Customer Assistance WarrantyIntroduction Operation
Quick Start
1.Press and hold the Power button
to turn onyour radio.
2.Press the Channel Up or Channel Down
button to select a channel.
Both radios must be tuned to the
same channel/privacy code to
communicate.
3.Press and hold the Talk button while
speaking into the microphone.
4.When finished talking, release the Talk
button and listen for a response.
On/Off Power
BatteryLow
Battery Save Mode
Talk Button
Two Inches (5 cm)
from Mouth
Insert Radio(s)
10293_LI7200WX_vB.qxd 9/5/07 10:55 AM Page 2