Advanced Operation

Operating Your Radio

Dual-Watch

Dual-Watchgives you one (1) button access to scan the two (2) locations of most importance to you. Channel 16 will always be included as a scanned location. The remaining location will be the VHF channel in effect when you enter Dual-Watchmode.

NOTE

The radio must be squelched for dual-watch to function. See page 36 for squelch procedure.

Operating Your Radio

Scanning

15

8830

75 60

Advanced Operation

Scan

During Scan, the radio will rapidly switch from channel

to channel through all the channels. Whenever any activity is detected, the radio will stop the scan for ten (10) seconds to allow you to listen briefly on that channel. It will then continue to scan unless you switch out of the Scan mode.

NOTE

Standby Mode

Dual-Watch Button

Dual-Watch Mode

To Enter Dual-Watch Mode:

1.In Standby mode, use the Up/Down buttons to go

to the channel you want to add as the second location to be scanned.

2.Press the Dual-Watchbutton.

Dual-watch will be indicated on the LCD and the radio will scan between Channel 16 and the second dual-watch location you selected. A signal on any one (1) of the two (2) channels will stop the scan to allow you to listen to the traffic on the channel. The channel number will be displayed on the LCD.

To Exit Dual-Watch Mode:

Press the Dual-Watchbutton. The radio will return to Standby mode.

During Dual-Watch (while receiving an incoming transmission), You Can Choose From The Following:

Press the Talk button to remain on that dual-watch location and return to Standby mode.

Press the Up/Down buttons to resume scanning dual-watch locations.

If you do not press any buttons, your radio will automatically resume scanning dual-watch locations when the incoming transmission is complete.

During Dual-Watch (while not receiving a transmission):

Press the Talk button to communicate on the last dual-watch location scanned and return to Standby mode.

Scan Button

Scan

The radio must be squelched for Scan mode to function. See page 36 for squelch procedure.

To Enter Scan:

From Standby mode, press the Scan button.

The radio will immediately begin to scan the entire channel map selected in the active channel map. SCAN will show on the LCD.

To Exit Scan:

From Scan mode, press the Scan button.

This will return the radio to Standby mode on the last scanned channel.

During Scan (while receiving an incoming transmission), You Can Choose From The Following:

Press the Talk button to remain on that channel and end scanning. This will return the radio to Standby mode.

Press the Up/Down buttons to resume scanning.

If you do not press any buttons within ten (10) seconds, your radio will automatically resume scanning.

During Scan (while not receiving a transmission):

Press the Talk button to communicate on the last channel scanned and return to Standby mode.

46 English

Nothing Comes Close to a Cobra® 47

Page 26
Image 26
Cobra Electronics MRF45 owner manual Dual-Watch, Scan