Cobra Electronics PR260 WX Caring for Your microTALK Radio, To charge batteries in radio

Introduction Operation Customer Assistance Warranty

Caring for Your microTALK® Radio

•

Your microTALK® radio will give you years of trouble-free service if cared for properly. Handle the radio gently. Keep the radio away from dust. Never put the radio in water or in a damp place. Avoid exposure to extreme temperatures.

Remove Belt Clip

Rechargeable Batteries and Charger

To install or replace batteries:

•

Pull Up Lock Latch

Insert Batteries

1.Release belt clip and pull up.

2.Press the battery door latch to

remove the battery compartment cover.

3.Insert the supplied four (4) AAA rechargeable batteries or non-rechargeable alkaline batteries. Position batteries according to polarity markings.

4.Replace battery compartment cover and belt clip.

Radio Charger Jack

To charge batteries in radio:

1.Check to see that the batteries have been inserted properly.

2.Insert the wall charger/adapter into the charge jack located at the top of the radio. The wall charger/adapter has two round connectors which enables you to charge either one or two radios at a time.

3.Plug the wall charger/adapter into electrical outlet.

It normally takes 15 hours to fully recharge batteries. It is not recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 8 hours.

Use only the supplied rechargeable batteries and wall charger/adapter for recharging your Cobra microTALK® radio.

1