USERUSER--MAINTENANCEMAINTENANCE INSTRUCTIONSINSTRUCTIONS

Air Motor Lubrication

To maintain the maximum performance of the air tool, it must be lubricated each time it is used. Dust, dirt, rust and oil residue will build up inside the tool and reduce the performance. An in-line oiler is recommended for proper auto- matic tool lubrication (see Figure 1). If an in-line oiler is not available, the tool can be lubricated manually through the inlet port (see Figure 3).

1.Disconnect the air tool from the air supply.

2.Turn the tool upside down and while depressing the trigger, add 4-6 drops of Coleman Powermate® air tool oil #018-0059SP or SAE10 nondetergent oil into the air inlet. NOTE: Depressing the trigger helps circulate oil in the

air motor.

Figure 3

 

3.Reconnect the tool to the air supply, cover the exhaust port end with a

towel and run in forward and reverse directions for approximately 30 seconds to remove excess oil.

NOTE: If the tool remains sluggish after it has been lubricated, the internal components may need to be cleaned.

To Clean:

Disconnect the air tool from the air supply and pour or spray a generous amount of WD-40® into the air inlet with the trigger depressed. Connect the tool to the air supply, cover the exhaust port end with a towel and run in forward and reverse directions for approximately 30 seconds. Follow the air motor lubrication instructions above after cleaning is completed to re-lubricate the tool.

After oiling or cleaning, cover the exhaust port with a towel and operate the tool for a few seconds to safely remove the excess oil. Clean the handle and surface of the tool of any oil residue. Failure to cover the exhaust port and clean the tool, can

result in serious injury. Note: Keep the towel away from moving parts!

TROUBLESHOOTINGG GUIDEGUIDE

SYMPTOM

POSSIBLE CAUSE(S)

CORRECTIVE ACTION

 

 

 

Tool will not run or runs

Grit in tool; tool gummed up

Clean the air motor inside the tool with WD-40®

slowly

 

(see “user maintenance” section).

 

No oil in tool

Add 4-6 drops of air tool oil into the air inlet of the

 

 

tool (see “user maintenance” section).

 

Low air pressure

Adjust compressor regulator to 90 PSI.

 

Air hose leaks

Tighten and seal hose fittings with Teflon® tape if

 

 

leaks are found.

 

 

 

 

TOOL SPECIFICATIONSTIONS

Maximum Torque

50 ft/lbs

Average SCFM Requirements

4.0 SCFM @ 90 PSI

Recommended Hose Size

3/8”

Air Inlet

1/4” NPT (female)

Square Drive

3/8”

Maximum Working Pressure

90 PSI

5 - ENG

Page 37
Image 37
Coleman 024-0075CT warranty Troubleshootingg Guideguide